YG6X tungsten carbide drawing dies excellent corrosion resistance and wear performance, mainly suitable for the production of less than ¢ 6.00mm bore drawing drawing dies. Hardness of not less than 91.5HRA, density is about 14.95g/mm ³. Flexural strength is about 1800MPa, the center of all holes have a certain shape, round, square, octagonal, or other special shapes. Has a strong compressive pressure can be used. Carbide brittle nature, can not guarantee that it does not break. Therefore, extreme caution when handling. As a high-quality carbide core, with high hardness, good thermal conductivity, low coefficient of friction characteristics. There are a variety of sizes are available for selection, cost savings, poor conditions applicable to the use of brushed occasions.
2014年5月8日星期四
YG6X Tungsten Carbide Drawing Dies Introduction
YG6X tungsten carbide drawing dies excellent corrosion resistance and wear performance, mainly suitable for the production of less than ¢ 6.00mm bore drawing drawing dies. Hardness of not less than 91.5HRA, density is about 14.95g/mm ³. Flexural strength is about 1800MPa, the center of all holes have a certain shape, round, square, octagonal, or other special shapes. Has a strong compressive pressure can be used. Carbide brittle nature, can not guarantee that it does not break. Therefore, extreme caution when handling. As a high-quality carbide core, with high hardness, good thermal conductivity, low coefficient of friction characteristics. There are a variety of sizes are available for selection, cost savings, poor conditions applicable to the use of brushed occasions.
订阅：
博文评论 (Atom)
没有评论:
发表评论