TL40.5 tungsten carbide drawing dies hardness of not less than 81HRA, mainly used in the manufacture of standard parts, carbide industry with cold red bearings, tools, molds and warheads and shells cold stamping molds. Density of 13.0 g / mm ³ to 13.6 g / mm ³, bending strength is about 2480MPa. Have a certain shape of the hole all centers, round, square, octagonal, or other special shapes. Has a strong compressive pressure can be used. Carbide brittle nature, can not guarantee that it does not break. Therefore, extreme caution when handling. As a high-quality carbide core, with high hardness, good thermal conductivity, low coefficient of friction characteristics. Excellent corrosion resistance and wear performance, a variety of sizes available for selection and cost savings.2014年5月8日星期四
TL40.5 Tungsten Carbide Drawing Dies Introduction
TL40.5 tungsten carbide drawing dies hardness of not less than 81HRA, mainly used in the manufacture of standard parts, carbide industry with cold red bearings, tools, molds and warheads and shells cold stamping molds. Density of 13.0 g / mm ³ to 13.6 g / mm ³, bending strength is about 2480MPa. Have a certain shape of the hole all centers, round, square, octagonal, or other special shapes. Has a strong compressive pressure can be used. Carbide brittle nature, can not guarantee that it does not break. Therefore, extreme caution when handling. As a high-quality carbide core, with high hardness, good thermal conductivity, low coefficient of friction characteristics. Excellent corrosion resistance and wear performance, a variety of sizes available for selection and cost savings.
订阅：
博文评论 (Atom)
没有评论:
发表评论