YS2T tungsten carbide burrs hardness of not less than 91.5 HRA, alloys belonging to ultrafine particles, mainly for low-speed rough turning, milling heat-resistant alloys and titanium, for cutters and taps, blade cutter better. Flexural strength of not less than 2200MPa, between 14.4g/cm³ -14.6g/cm³ density ranging, including the amount of tungsten in the range of 83-89%, the cobalt content of 5% and 8%, plus or minus, with titanium content of 0% to 1% range, with tantalum content of 0% to 2%. YS2T burrs can not only use it to process a variety of metal materials processing ≤ HRC65 also hardened steel can be replaced by small emery wheels and there is no dust pollution. Its production efficiency than using hand tools can improve several times.
2014年7月10日星期四
YS2T Tungsten Carbide Burrs Introduction
YS2T tungsten carbide burrs hardness of not less than 91.5 HRA, alloys belonging to ultrafine particles, mainly for low-speed rough turning, milling heat-resistant alloys and titanium, for cutters and taps, blade cutter better. Flexural strength of not less than 2200MPa, between 14.4g/cm³ -14.6g/cm³ density ranging, including the amount of tungsten in the range of 83-89%, the cobalt content of 5% and 8%, plus or minus, with titanium content of 0% to 1% range, with tantalum content of 0% to 2%. YS2T burrs can not only use it to process a variety of metal materials processing ≤ HRC65 also hardened steel can be replaced by small emery wheels and there is no dust pollution. Its production efficiency than using hand tools can improve several times.
订阅：
博文评论 (Atom)
没有评论:
发表评论